March 26th, 2007

(no subject)

Ok. Here is the DJ set I recorded.

Spring Fever

01. Above & Beyond - Good For Me (LDJ's Intro Edit - Thomas Datt Remix)
02. Markus Schulz - Without You Near (Coldharbour Edit)
03. Reflekt feat. Deline Bass - Need To Feel Loved (12" Club Mix)
04. Imogen Heap - Hide and Seek (Randy Boyer & Eric Tadler aka EnMass remix)
05. Dogzilla - Without You (Dogzilla dub)
06. Delerium - After All (Svenson & Gielen remix)
07. Kyau vs. Albert - Falling Anywhere (Rework)
08. Darren Tate vs. Jono Grant - Nocturnal Creatures (Jono remix)

I just put the artist down as "8 bit" for now. I don't really like it that much.



And just for deusdiabolus:

I know the transitions are pretty awful, but I produced this with Native Instruments Traktor DJ Studio. I don't have a second sound card, so I had no way to put any of the music in audition mode or listen to it through headphones outside of what was being recorded. So I had to record the tempo adjustments and everything by ear as the sound was being recorded to the file.

Also, this made me think of you:

cars - Miata

I love when things check themselves off my list for me

Done:
  1. remove strut brace
  2. remove plug wires
  3. remove valve cover and gasket
  4. remove bad coil pack
  5. remove passenger seat and disassemble interior
  6. pull up passenger floor panel
  7. replace ECU
  8. remove shifter
  9. drain and remove transmission
  10. replace clutch and flywheel
  11. re-install transmission
  12. remove old intake
  13. remove old heat shield
  14. remove auxiliary fuel pressure regulator
  15. remove MSD ignition box
  16. install knock sensor
  17. get wideband O2 sensor bung welded to downpipe
  18. re-install rear power plant frame bolts
  19. put driveshaft back on
  20. find the exhaust gasket I know is around somewhere
  21. put the exhaust back on
  22. install coil pack and plug wires
  23. install valve cover gasket & valve cover
  24. aluminum sensor bung has arrived
  25. new hose connector for intake has arrived
To do:
  1. install the new intake
  2. have bung welded to intercooler pipe
  3. install and wire the air temp sensor
  4. reinstall all the turbo plumbing
  5. install wideband O2 sensor
  6. replace the turbo's water and oil hoses
  7. run wires to the knock sensor
  8. fab bracket for electronic boost control solenoid
  9. install, wire and plumb solenoid
  10. buy, install and wire cockpit switch for low/hi boost
  11. run wire from ECU to signal wire so I don't have to have the AFM
  12. install clutch switch override
  13. make sure all sensor wires and the vacuum tube are run from the ECU
  14. enlarge, file down and seal firewall hole
  15. install new heat shield
  16. fill transmission with fluid
  17. change oil and oil filter
  18. tune ECU
  19. Start engine, make sure nothing is leaking.  Particularly fuel injectors, water hoses at the firewall, fuel lines where AFPR used to be
  20. put the passenger seat back in and the rest of the interior back together
  21. wash car
  22. go zoom